Worm screw lift at work, its surface temperature should be controlled within the range of -15 ° C ~ 80 ° C, the temperature under normal operating conditions must not exceed 45 ° C, as high temperatures should be checked immediately. Screw lift mounted on the bearing should be noted that the main problem is that the rolling bearings installed in our time, the bearing inner ring should be close to the shaft shoulder, general requirements for the gap should not exceed 0.05mm thick feeler. Reasons of high temperature screw jack screw lift is usually chosen to produce small tonnage overload phenomenon, or worm and worm wheel cover with hot pressed into tight situations arise, the input speed is not excluded. Worm screw lift for grease lubrication, worm screw lift shaft shall not exceed the maximum speed 1000min / s, as there will be a high input speed is too high and stuck, etc., the high temperature treatment is to reduce the input speed, check the gland embedded fit is not too tight, and whether screw lift in oil phenomenon. Swim gear in the interstitial bearing can not be adjusted, usually the axial clearance is 0.25 ~ 0.4mm, the tapered roller bearing clearance to the junction of ball bearing axial clearance. Reducer bearing note in the installation instructions say specifically addressed, the high degree of attention, and serious responsible swl35 screw lift, making the bearing can be a good contact. To sum up the reason must pay attention to the choice of the lift screw shaft speed to match the loads screw lift, lift the maximum load allowed for allowing the applied load, the rotational speed of the screw shaft to allow projects such as parity, if more than data products will cause significant damage to the overall lift equipment. WL series worm screw lift Products: 1, Transmission Type: silk worm gear drive transmission lever 2, the driving source: handle (manual); AC / DC motors; gas-liquid motor (pump) 3, the installation forms: vertical ; inverted; vertical rotary; rotary inverted; horizontal pusher 4, ordinary spiral lift characteristics: (1) thrust range: 0.25-250 t (2) travel up to 8m, duty 30% (3. ) The speed of less than 1500mm / min (4). efficiency of less than 25%, the absolute self-locking (5). The accuracy of location, additional anti-backlash system accuracy to 0.02mm (6). absolute synchronization, the same motor can drive more than one swl10 screw screw jacks lift, mechanical synchronization (7). Can be equipped with encoder, limit switches, dust cover, etc. (8) The operation and maintenance is simple, low noise jrss screw lift _ Runchi reducer (certified) _ Cangzhou screw lift from Texas Runchi reducer Limited. Texas Runchi reducer Limited (www.sddzjsj.com) is a leader in Dezhou, reducer, gearbox, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In Runchi reducer leadership with the staff warmly welcome all inquiries negotiations to create Runchi reducer a better future.